* drivers. When promted, direct your OS to install Atmel's AVRISP-MKII drivers provided with AVRStudio.\r
*\r
* Note that this design currently has several limitations:\r
- * - Minimum target clock speed of 500KHz due to hardware SPI used\r
+ * - Minimum ISP target clock speed of 500KHz due to hardware SPI used\r
* - No reversed/shorted target connector detection and notification\r
*\r
- * On AVR models with an ADC converter, ACC should be tied to 5V (e.g. VBUS) and the VTARGET_ADC_CHANNEL token should be\r
+ * On AVR models with an ADC converter, AVCC should be tied to 5V (e.g. VBUS) and the VTARGET_ADC_CHANNEL token should be\r
* set to an appropriate ADC channel number in the project makefile for VTARGET detection to operate correctly. On models\r
* without an ADC converter, VTARGET will report at a fixed 5V level.\r
*\r
* <tr>\r
* <td><b>Programmer Pin:</b></td>\r
* <td><b>Target Device Pin:</b></td>\r
- * <td><b>ISP 6 Pin Layout:</b></td>\r
+ * <td><b>PDI 6 Pin Layout:</b></td>\r
* </tr>\r
* <tr>\r
* <td>MISO</td>\r
* <td>ADC channel number (on supported AVRs) to use for VTARGET level detection.</td> \r
* </tr>\r
* <tr>\r
- * <td>ENABLE_SPI_PROTOCOL</td>\r
+ * <td>ENABLE_ISP_PROTOCOL</td>\r
* <td>Makefile CDEFS</td>\r
* <td>Define to enable SPI programming protocol support. <i>Ignored when compiled for the XPLAIN board.</i></td> \r
* </tr>\r
* <tr>\r
- * <td>ENABLE_XPROG_PROTOCOL</td>\r
+ * <td>ENABLE_PDI_PROTOCOL</td>\r
* <td>Makefile CDEFS</td>\r
* <td>Define to enable XMEGA PDI programming protocol support. <i>Ignored when compiled for the XPLAIN board.</i></td> \r
* </tr>\r
projects / pub / USBasp.git / blobdiff