X-Git-Url: http://git.linex4red.de/pub/USBasp.git/blobdiff_plain/f1baf12fae61a13e6d8e88655d709d74977322b5..7a9b3d3641e1bc97d2826b4865b3cedb11099e62:/Projects/AVRISP/AVRISP.txt
diff --git a/Projects/AVRISP/AVRISP.txt b/Projects/AVRISP/AVRISP.txt
index bed0a7a62..c15c27fa6 100644
--- a/Projects/AVRISP/AVRISP.txt
+++ b/Projects/AVRISP/AVRISP.txt
@@ -54,10 +54,10 @@
* drivers. When promted, direct your OS to install Atmel's AVRISP-MKII drivers provided with AVRStudio.
*
* Note that this design currently has several limitations:
- * - Minimum target clock speed of 500KHz due to hardware SPI used
+ * - Minimum ISP target clock speed of 500KHz due to hardware SPI used
* - No reversed/shorted target connector detection and notification
*
- * On AVR models with an ADC converter, ACC should be tied to 5V (e.g. VBUS) and the VTARGET_ADC_CHANNEL token should be
+ * On AVR models with an ADC converter, AVCC should be tied to 5V (e.g. VBUS) and the VTARGET_ADC_CHANNEL token should be
* set to an appropriate ADC channel number in the project makefile for VTARGET detection to operate correctly. On models
* without an ADC converter, VTARGET will report at a fixed 5V level.
*
@@ -115,7 +115,7 @@
*
* | Programmer Pin: |
* Target Device Pin: |
- * ISP 6 Pin Layout: |
+ * PDI 6 Pin Layout: |
*
*
* | MISO |
@@ -183,12 +183,12 @@
* ADC channel number (on supported AVRs) to use for VTARGET level detection. |
*
*
- * | ENABLE_SPI_PROTOCOL |
+ * ENABLE_ISP_PROTOCOL |
* Makefile CDEFS |
* Define to enable SPI programming protocol support. Ignored when compiled for the XPLAIN board. |
*
*
- * | ENABLE_XPROG_PROTOCOL |
+ * ENABLE_PDI_PROTOCOL |
* Makefile CDEFS |
* Define to enable XMEGA PDI programming protocol support. Ignored when compiled for the XPLAIN board. |
*