Make device mode configure the control endpoint even before the bus has been reset...

diff --git a/LUFA/Drivers/USB/LowLevel/USBController.c b/LUFA/Drivers/USB/LowLevel/USBController.c
index 49bd05b..f720777 100644 (file)
--- a/LUFA/Drivers/USB/LowLevel/USBController.c
+++ b/LUFA/Drivers/USB/LowLevel/USBController.c
@@ -60,6 +60,11 @@ void USB_Init(
        USB_Options = Options;
        #endif
        
+       if (!(USB_Options & USB_OPT_REG_DISABLED))
+         USB_REG_On();
+       else
+         USB_REG_Off();
+
        #if defined(USB_CAN_BE_BOTH)
        if (Mode == USB_MODE_UID)
        {
@@ -112,11 +117,6 @@ void USB_ResetInterface(void)
        USB_INT_ClearAllInterrupts();
        
        USB_Controller_Reset();
-
-       if (!(USB_Options & USB_OPT_REG_DISABLED))
-         USB_REG_On();
-       else
-         USB_REG_Off();
          
        if (!(USB_Options & USB_OPT_MANUAL_PLL))
        {
@@ -126,9 +126,7 @@ void USB_ResetInterface(void)
 
                USB_PLL_On();
                while (!(USB_PLL_IsReady()));
-       }         
-
-       USB_CLK_Unfreeze();
+       }
 
        #if defined(USB_CAN_BE_BOTH)
        if (UIDModeSelectEnabled)
@@ -137,6 +135,8 @@ void USB_ResetInterface(void)
                USB_INT_Enable(USB_INT_IDTI);
        }
        #endif
+
+       USB_CLK_Unfreeze();
        
        if (USB_CurrentMode == USB_MODE_DEVICE)
        {
@@ -159,8 +159,6 @@ void USB_ResetInterface(void)
        #if (defined(USB_SERIES_6_AVR) || defined(USB_SERIES_7_AVR))
        USB_OTGPAD_On();
        #endif
-       
-       USB_Attach();
 }
 
 #if defined(USB_CAN_BE_DEVICE)
@@ -201,10 +199,14 @@ static void USB_Init_Device(void)
        USB_INT_Enable(USB_INT_VBUS);
        #endif
 
-       USB_INT_Clear(USB_INT_SUSPEND);
+       Endpoint_ConfigureEndpoint(ENDPOINT_CONTROLEP, EP_TYPE_CONTROL,
+                                                          ENDPOINT_DIR_OUT, USB_ControlEndpointSize,
+                                                          ENDPOINT_BANK_SINGLE);               
+
        USB_INT_Enable(USB_INT_SUSPEND);
-       USB_INT_Clear(USB_INT_EORSTI);
        USB_INT_Enable(USB_INT_EORSTI);
+
+       USB_Attach();
 }
 #endif