Minor corrections to the library Doxygen documentation.

[pub/lufa.git] / LUFA / GettingStarted.txt

diff --git a/LUFA/GettingStarted.txt b/LUFA/GettingStarted.txt
index a88a825..1ff36ec 100644 (file)
--- a/LUFA/GettingStarted.txt
+++ b/LUFA/GettingStarted.txt
@@ -12,12 +12,14 @@
  *  This is due to two reasons; one, it is the hardware the author posesses, and two, it is the most popular Atmel\r
  *  USB demonstration board to date.\r
  *\r
+ *\r
  *  \section Sec_Prerequisites Prerequisites\r
  *  Before you can compile any of the LUFA library code or demos, you will need a recent distribution of avr-libc (1.6.2+)\r
  *  and the AVR-GCC (4.2+) compiler. For Windows users, the best way to obtain these is the WinAVR project\r
  *  (http://winavr.sourceforge.net) as this provides a single-file setup for everything required to compile your\r
  *  own AVR projects.\r
  *\r
+ *\r
  *  \section Sec_Configuring Configuring the Demos, Bootloaders and Projects\r
  *  If the target AVR model, clock speed, board or other settings are different to the current settings, they must be changed\r
  *  and the project recompiled from the source code before being programmed into the AVR microcontroller. Most project\r
@@ -34,7 +36,8 @@
  *\r
  *    - <b>MCU</b>, the target AVR processor.\r
  *    - <b>BOARD</b>, the target board hardware\r
- *    - <b>F_CPU</b>, the target AVR master clock frequency\r
+ *    - <b>F_CLOCK</b>, the target raw master clock frequency, before any prescaling is performed\r
+ *    - <b>F_CPU</b>, the target AVR CPU master clock frequency, after any prescaling\r
  *    - <b>CDEFS</b>, the C preprocessor defines which configure the source code\r
  *\r
  *  These values should be changed to reflect the build hardware.\r
@@ -83,6 +86,7 @@
  *  interface speed (Low or Full speed) and other LUFA configuration options can be set here - refer to the library documentation for details on the\r
  *  configuration parameters.\r
  *\r
+ *\r
  *  \section Sec_Compiling Compiling a LUFA Application\r
  *  Compiling the LUFA demos, applications and/or bootloaders is very simple. LUFA comes with makefile scripts for\r
  *  each individual demo, bootloader and project folder, as well as scripts in the /Demos/, /Bootloaders/, /Projects/\r
@@ -103,6 +107,7 @@
  *  in AVRStudio, the project can be built and cleaned using the GUI buttons or menus. Note that the AVRStudio project files make\r
  *  use of the external project makefile, thus the procedure for configuring a demo remains the same regardless of the build environment.\r
  *\r
+ *\r
  *  \section Sec_Programming Programming a USB AVR\r
  *  Once you have built an application, you will need a way to program in the resulting ".HEX" file (and, if your\r
  *  application uses EEPROM variables with initial values, also a ".EEP" file) into your USB AVR. Normally, the\r