X-Git-Url: http://git.linex4red.de/pub/lufa.git/blobdiff_plain/4c637c93ba69e33c77034eef9bd4433252e139fc..refs/heads/master:/Bootloaders/DFU/BootloaderDFU.txt?ds=inline

diff --git a/Bootloaders/DFU/BootloaderDFU.txt b/Bootloaders/DFU/BootloaderDFU.txt
index d0bb6e120..b2540a5b6 100644
--- a/Bootloaders/DFU/BootloaderDFU.txt
+++ b/Bootloaders/DFU/BootloaderDFU.txt
@@ -62,9 +62,9 @@
  *
  *  The are two behaviours of this bootloader, depending on the device's fuses:
  *
- *  <b>If the device's BOOTRST fuse is set</b>, the bootloader will run any time the system is not reset from
+ *  <b>If the device's BOOTRST fuse is set</b>, the bootloader will run any time the system is reset from
  *  the external reset pin, unless no valid user application has been loaded. To initiate the bootloader, the
- *  device's external reset pin should be grounded.
+ *  device's external reset pin should be grounded momentarily.
  *
  *  <b>If the device's BOOTRST fuse is not set</b>, the bootloader will run only if initiated via a software
  *  jump, or if the \c HWB pin was low during the last device reset (if the \c HWBE fuse is set).
@@ -213,12 +213,6 @@
  *  access.
  *  See <a href=https://groups.google.com/d/msg/lufa-support/CP9cy2bc8yo/kBqsOu-RBeMJ>here</a> for resolution steps.
  *
- *  \par After loading an application, it is not run automatically on startup.
- *  Some USB AVR boards ship with the BOOTRST fuse set, causing the bootloader
- *  to run automatically when the device is reset. In most cases, the BOOTRST
- *  fuse should be disabled and the HWBE fuse used instead to run the bootloader
- *  when needed.
- *
  *  \section Sec_Options Project Options
  *
  *  The following defines can be found in this demo, which can control the demo behaviour when defined, or changed in value.