X-Git-Url: http://git.linex4red.de/pub/lufa.git/blobdiff_plain/34047efc7ee3bd765574d2ce709712ff27c7b2fd..141d94fa980b6056c1922cbfeb9f5535227331c5:/LUFA/ManPages/ChangeLog.txt

diff --git a/LUFA/ManPages/ChangeLog.txt b/LUFA/ManPages/ChangeLog.txt
index f04fbe437..0e51f21ad 100644
--- a/LUFA/ManPages/ChangeLog.txt
+++ b/LUFA/ManPages/ChangeLog.txt
@@ -8,23 +8,18 @@
   *
   *  \section Sec_ChangeLogXXXXXX Version XXXXXX
   *  <b>New:</b>
+  *  - Added new ADC_DisableChannel() function (thanks to Mich Davis)
   *
   *  <b>Changed:</b>
-  *  - The TeensyHID bootloader has been removed, per request from Paul at PJRC
-  *  - The LIBUSB_FILTERDRV_COMPAT compile time option in the XPLAINBridge and AVRISP-MKII projects has been renamed
-  *    LIBUSB_DRIVER_COMPAT, as it applies to all software on all platforms using the libUSB driver
+  *  - N/A
   *
   *  <b>Fixed:</b>
-  *  - Fixed possible device lockup when INTERRUPT_CONTROL_ENDPOINT is enabled and the control endpoint is not properly
-  *    selected when the ISR completes
-  *  - Fixed AVRISP-MKII clone project not correctly issuing LOAD EXTENDED ADDRESS commands when the extended address
-  *    boundary is crossed during programming or readback (thanks to Gerard Sexton)
-  *  - Fixed warnings when building the AVRISP-MKII clone project with the ENABLE_XPROG_PROTOCOL compile time option disabled
-  *  - Remove incorrect check for the current device state in the Set Configuration request handler of DevChapter9, which broke
-  *    Set Configuration requests to the device under most circumstances.
-  *
-  *  \section Sec_ChangeLog100512 Version 100512
+  *  - Fixed AVRISP project sending a LOAD EXTENDED ADDRESS command to 128KB AVRs after programming or reading from
+  *    the last page of FLASH (thanks to Gerard Sexton)
+  *  - Fixed AVRISP project not sending a full erase-and-write EEPROM command to XMEGA targets when writing to the EEPROM
+  *    instead of the split write-only command (thanks to Tim Margush)
   *
+  *  \section Sec_ChangeLog100513 Version 100513
   *  <b>New:</b>
   *  - Added incomplete MIDIToneGenerator project
   *  - Added new Relay Controller Board project (thanks to OBinou)
@@ -62,8 +57,16 @@
   *    properly reset to their defaults
   *  - Device mode class driver callbacks are now fired before the control request status stage is sent to prevent the host from
   *    timing out if another request is immediately fired and the device has a lengthy callback routine
+  *  - The TeensyHID bootloader has been removed, per request from Paul at PJRC
+  *  - The LIBUSB_FILTERDRV_COMPAT compile time option in the XPLAINBridge and AVRISP-MKII projects has been renamed
+  *    LIBUSB_DRIVER_COMPAT, as it applies to all software on all platforms using the libUSB driver
   *
   *  <b>Fixed:</b>
+  *  - Fixed possible device lockup when INTERRUPT_CONTROL_ENDPOINT is enabled and the control endpoint is not properly
+  *    selected when the ISR completes
+  *  - Fixed AVRISP-MKII clone project not correctly issuing LOAD EXTENDED ADDRESS commands when the extended address
+  *    boundary is crossed during programming or readback (thanks to Gerard Sexton)
+  *  - Fixed warnings when building the AVRISP-MKII clone project with the ENABLE_XPROG_PROTOCOL compile time option disabled
   *  - Fixed software PDI/TPI programming mode in the AVRISP project not correctly toggling just the clock pin
   *  - Fixed TWI_StartTransmission() corrupting the contents of the GPIOR0 register
   *  - Fixed TWI driver not aborting when faced with no response after attempting to address a device on the bus