Add Leonardo compatibility to most bootloaders, run user application if BOOTRST fuse...

[pub/lufa.git] / Bootloaders / MassStorage / BootloaderMassStorage.txt

diff --git a/Bootloaders/MassStorage/BootloaderMassStorage.txt b/Bootloaders/MassStorage/BootloaderMassStorage.txt
index e094847..467972c 100644 (file)
--- a/Bootloaders/MassStorage/BootloaderMassStorage.txt
+++ b/Bootloaders/MassStorage/BootloaderMassStorage.txt
@@ -62,9 +62,17 @@
  *
  *  \section Sec_Running Running the Bootloader
  *
- *  This bootloader is designed to be started via the HWB mechanism of the USB AVRs; ground the HWB pin (see device
- *  datasheet) then momentarily ground /RESET to start the bootloader. This assumes the HWBE fuse is set and the BOOTRST
- *  fuse is cleared.
+ *  On the USB AVR8 devices, setting the \c HWBE device fuse will cause the bootloader to run if the \c HWB pin of
+ *  the AVR is grounded when the device is reset.
+ *
+ *  The are two behaviours of this bootloader, depending on the device's fuses:
+ *
+ *  <b>If the device's BOOTRST fuse is set</b>, the bootloader will run any time the system is not reset from
+ *  the external reset pin, unless no valid user application has been loaded. To initiate the bootloader, the
+ *  device's external reset pin should be grounded.
+ *
+ *  <b>If the device's BOOTRST fuse is not set</b>, the bootloader will run only if initiated via a software
+ *  jump, or if the \c HWB pin was low during the last device reset (if the \c HWBE fuse is set).
  *
  *  For board specific exceptions to the above, see below.
  *