Only issue the REPEAT instruction in the clone programmer if needed to reduce protoco...

[pub/lufa.git] / LUFA / Drivers / Peripheral / AVR8 / TWI_AVR8.h

diff --git a/LUFA/Drivers/Peripheral/AVR8/TWI_AVR8.h b/LUFA/Drivers/Peripheral/AVR8/TWI_AVR8.h
index c0a9067..498138f 100644 (file)
--- a/LUFA/Drivers/Peripheral/AVR8/TWI_AVR8.h
+++ b/LUFA/Drivers/Peripheral/AVR8/TWI_AVR8.h
@@ -40,13 +40,13 @@
 /** \ingroup Group_TWI
  *  \defgroup Group_TWI_AVR8 TWI Peripheral Driver (AVR8)
  *
- *  \section Sec_ModDescription Module Description
+ *  \section Sec_TWI_AVR8_ModDescription Module Description
  *  Master mode TWI driver for the 8-bit AVR microcontrollers which contain a hardware TWI module.
  *
  *  \note This file should not be included directly. It is automatically included as needed by the TWI driver
  *        dispatch header located in LUFA/Drivers/Peripheral/TWI.h.
  *
- *  \section Sec_ExampleUsage Example Usage
+ *  \section Sec_TWI_AVR8_ExampleUsage Example Usage
  *  The following snippet is an example of how this module may be used within a typical
  *  application.
  *
@@ -201,8 +201,10 @@
                         *  \param[in] Prescale   Prescaler to use when determining the bus frequency, a \c TWI_BIT_PRESCALE_* value.
                         *  \param[in] BitLength  Length of the bits sent on the bus.
                         */
-                       static inline void TWI_Init(const uint8_t Prescale, const uint8_t BitLength) ATTR_ALWAYS_INLINE;
-                       static inline void TWI_Init(const uint8_t Prescale, const uint8_t BitLength)
+                       static inline void TWI_Init(const uint8_t Prescale,
+                                                   const uint8_t BitLength) ATTR_ALWAYS_INLINE;
+                       static inline void TWI_Init(const uint8_t Prescale,
+                                                   const uint8_t BitLength)
                        {
                                TWCR |= (1 << TWEN);
                                TWSR  = Prescale;