*
* \section Sec_ChangeLogXXXXXX Version XXXXXX
* <b>New:</b>
+ * - Added new ADC_DisableChannel() function (thanks to Mich Davis)
+ * - Added new VTARGET_REF_VOLTS and VTARGET_SCALE_FACTOR compile time defines to the AVRISP-MKII programmer project to set
+ * the VTARGET reference voltage and scale factor
*
* <b>Changed:</b>
- * - The TeensyHID bootloader has been removed, per request from Paul at PJRC
- * - The LIBUSB_FILTERDRV_COMPAT compile time option in the XPLAINBridge and AVRISP-MKII projects has been renamed
- * LIBUSB_DRIVER_COMPAT, as it applies to all software on all platforms using the libUSB driver
+ * - The RingBuff library code has been replaced in the XPLAINBridge, Benito and USBtoSerial projects with an ultra lightweight
+ * ring buffer to help improve the reliability of the projects
+ * - The EEPROM stream read/write functions now use eeprom_update_byte() instead of eeprom_write_byte(), so that only
+ * changed bytes are written to EEPROM to preserve its lifespan
+ * - Changed over the AVRISP-MKII and TemperatureDataLogger projects to use eeprom_update_byte() when writing non-volatile
+ * parameters to EEPROM to preserve its lifespan
+ * - Removed unused line encoding data and control requests from the CDC Bootloader code, to save space
*
* <b>Fixed:</b>
- * - Fixed possible device lockup when INTERRUPT_CONTROL_ENDPOINT is enabled and the control endpoint is not properly
- * selected when the ISR completes
- * - Fixed AVRISP-MKII clone project not correctly issuing SET EXTENDED ADDRESS commands when the extended address
- * boundary is crossed during programming or readback (thanks to Gerard Sexton)
- * - Fixed warnings when building the AVRISP-MKII clone project with the ENABLE_XPROG_PROTOCOL compile time option disabled
- *
- * \section Sec_ChangeLog100512 Version 100512
- *
+ * - Fixed AVRISP project sending a LOAD EXTENDED ADDRESS command to 128KB AVRs after programming or reading from
+ * the last page of FLASH (thanks to Gerard Sexton)
+ * - Fixed AVRISP project not sending a full erase-and-write EEPROM command to XMEGA targets when writing to the EEPROM
+ * instead of the split write-only command (thanks to Tim Margush)
+ * - Fixed RNDISEthernet demos crashing when calculating checksums for Ethernet/TCP packets of more than ~500 bytes due to
+ * an overflow in the checksum calculation loop (thanks to Kevin Malec)
+ * - Fixed XPLAINBridge project not correctly reading the XMEGA's supply voltage when reporting back to the host
+ * - Fixed incorrect signature for the ATMEGA32U2 in the DFU bootloader (thanks to Axel Rohde)
+ * - Fixed internal device serial not being accessible on the ATMEGAXXU2 AVRs (thanks to Axel Rohde)
+ *
+ * \section Sec_ChangeLog100513 Version 100513
* <b>New:</b>
* - Added incomplete MIDIToneGenerator project
* - Added new Relay Controller Board project (thanks to OBinou)
* properly reset to their defaults
* - Device mode class driver callbacks are now fired before the control request status stage is sent to prevent the host from
* timing out if another request is immediately fired and the device has a lengthy callback routine
+ * - The TeensyHID bootloader has been removed, per request from Paul at PJRC
+ * - The LIBUSB_FILTERDRV_COMPAT compile time option in the XPLAINBridge and AVRISP-MKII projects has been renamed
+ * LIBUSB_DRIVER_COMPAT, as it applies to all software on all platforms using the libUSB driver
*
* <b>Fixed:</b>
+ * - Fixed possible device lockup when INTERRUPT_CONTROL_ENDPOINT is enabled and the control endpoint is not properly
+ * selected when the ISR completes
+ * - Fixed AVRISP-MKII clone project not correctly issuing LOAD EXTENDED ADDRESS commands when the extended address
+ * boundary is crossed during programming or readback (thanks to Gerard Sexton)
+ * - Fixed warnings when building the AVRISP-MKII clone project with the ENABLE_XPROG_PROTOCOL compile time option disabled
* - Fixed software PDI/TPI programming mode in the AVRISP project not correctly toggling just the clock pin
* - Fixed TWI_StartTransmission() corrupting the contents of the GPIOR0 register
* - Fixed TWI driver not aborting when faced with no response after attempting to address a device on the bus
* HID_HOST_BOOT_PROTOCOL_ONLY compile time option is set
* - Fixed INTERRUPT_CONTROL_ENDPOINT compile time option preventing other interrupts from occuring while the control endpoint
* request is being processed, causing possible lockups if a USB interrupt occurs during a transfer
- * - Fixed TeensyHID bootloader not working on some USB AVR models with the official TeensyLoader GUI application
* - Remove incorrect Abstract Call Management class specific descriptor from the CDC demos, bootloaders and projects
*
* \section Sec_ChangeLog100219 Version 100219
projects / pub / lufa.git / blobdiff