* This file contains special DoxyGen information for the generation of the main page and other special
* documentation pages. It is not a project source file.
*/
-
+
/** \page Page_ConfiguringApps Configuring the Demos, Bootloaders and Projects
*
- * If the target AVR model, clock speed, board or other settings are different to the current settings, they must be changed
+ * If the target AVR model, clock speed, board or other settings are different from the current settings, they must be changed
* and the project recompiled from the source code before being programmed into the AVR microcontroller. Most project
* configuration options are located in the "makefile" build script inside each LUFA application's folder, however some
- * demo or application-specific configuration settings (such as the output format in the AudioOut demo) are located in the
- * main .c source file of the project. See each project's individual documentation for application-specific configuration
+ * demo or application-specific configuration settings (such as the output format in the AudioOut demo) are located in one or
+ * more of the source files of the project. See each project's individual documentation for application-specific configuration
* values.
*
* Each project "makefile" contains all the script and configuration data required to compile each project. When opened with
* Inside each makefile, a number of configuration variables are located, with the format "<VARIABLE NAME> = <VALUE>". For
* each application, the important variables which should be altered are:
*
- * - <b>MCU</b>, the target AVR processor.
+ * - <b>MCU</b>, the target AVR processor
* - <b>BOARD</b>, the target board hardware
* - <b>F_CLOCK</b>, the target raw master clock frequency, before any prescaling is performed
* - <b>F_CPU</b>, the target AVR CPU master clock frequency, after any prescaling
* (such as the AT90USB1287, or the ATMEGA32U4), in all lower-case (e.g. "at90usb1287"). Note that not all demos support all the
* USB AVR models, as they may make use of peripherals or modes only present in some devices.
*
- * For supported library AVR models, see main documentation page.
+ * For supported processor models, see \ref Page_DeviceSupport.
*
* \section Sec_BOARD The BOARD Parameter
* This parameter indicates the target AVR board hardware for the compiled application. Some LUFA library drivers are board-specific,
* directory into a /Board/ folder inside the application directory, and the stub driver completed with the appropriate code to drive the
* custom board's hardware.
*
+ * For boards with built in hardware driver support within the LUFA library, see \ref Page_DeviceSupport.
+ *
* \section Sec_F_CLOCK The F_CLOCK Parameter
* This parameter indicates the target AVR's input clock frequency, in Hz. This is the actual clock input, before any prescaling is performed. In the
* USB AVR architecture, the input clock before any prescaling is fed directly to the PLL subsystem, and thus the PLL is derived directly from the
* model and cannot be made to function through the altering of the makefile settings alone (or at all). Settings such as the USB mode (device, host or both),
* the USB interface speed (Low or Full speed) and other LUFA configuration options can be set here - see \ref Page_TokenSummary documentation for details
* on the available LUFA compile time configuration options.
- */
\ No newline at end of file
+ */
projects / pub / lufa.git / blobdiff