More SDP code improvements - responses to ServiceSearchAttribute service discovery...

[pub/lufa.git] / LUFA / ManPages / ChangeLog.txt

diff --git a/LUFA/ManPages/ChangeLog.txt b/LUFA/ManPages/ChangeLog.txt
index 02b6296..0e51f21 100644 (file)
--- a/LUFA/ManPages/ChangeLog.txt
+++ b/LUFA/ManPages/ChangeLog.txt
@@ -7,7 +7,19 @@
  /** \page Page_ChangeLog Project Changelog
   *
   *  \section Sec_ChangeLogXXXXXX Version XXXXXX
+  *  <b>New:</b>
+  *  - Added new ADC_DisableChannel() function (thanks to Mich Davis)
+  *
+  *  <b>Changed:</b>
+  *  - N/A
+  *
+  *  <b>Fixed:</b>
+  *  - Fixed AVRISP project sending a LOAD EXTENDED ADDRESS command to 128KB AVRs after programming or reading from
+  *    the last page of FLASH (thanks to Gerard Sexton)
+  *  - Fixed AVRISP project not sending a full erase-and-write EEPROM command to XMEGA targets when writing to the EEPROM
+  *    instead of the split write-only command (thanks to Tim Margush)
   *
+  *  \section Sec_ChangeLog100513 Version 100513
   *  <b>New:</b>
   *  - Added incomplete MIDIToneGenerator project
   *  - Added new Relay Controller Board project (thanks to OBinou)
@@ -16,6 +28,10 @@
   *  - Added new ENDPOINT_*_BusSuspended error code to the Endpoint function, so that the stream functions early-abort if the bus
   *    is suspended before or during a transfer
   *  - Added new EVENT_CDC_Device_BreakSent() event and CDC_Host_SendBreak() function to the Device and Host CDC Class drivers
+  *  - Added ReportType parameter to the HID device class driver CALLBACK_HID_Device_ProcessHIDReport() function so that FEATURE
+  *    reports from the host to the device can be correctly processed
+  *  - Added ReportType parameter to the HID host class driver HID_Host_SendReportByID() function so that FEATURE reports can be
+  *    issued to the attached device
   *
   *  <b>Changed:</b>
   *  - AVRISP programmer project now has a more robust timeout system
@@ -41,8 +57,16 @@
   *    properly reset to their defaults
   *  - Device mode class driver callbacks are now fired before the control request status stage is sent to prevent the host from
   *    timing out if another request is immediately fired and the device has a lengthy callback routine
+  *  - The TeensyHID bootloader has been removed, per request from Paul at PJRC
+  *  - The LIBUSB_FILTERDRV_COMPAT compile time option in the XPLAINBridge and AVRISP-MKII projects has been renamed
+  *    LIBUSB_DRIVER_COMPAT, as it applies to all software on all platforms using the libUSB driver
   *
   *  <b>Fixed:</b>
+  *  - Fixed possible device lockup when INTERRUPT_CONTROL_ENDPOINT is enabled and the control endpoint is not properly
+  *    selected when the ISR completes
+  *  - Fixed AVRISP-MKII clone project not correctly issuing LOAD EXTENDED ADDRESS commands when the extended address
+  *    boundary is crossed during programming or readback (thanks to Gerard Sexton)
+  *  - Fixed warnings when building the AVRISP-MKII clone project with the ENABLE_XPROG_PROTOCOL compile time option disabled
   *  - Fixed software PDI/TPI programming mode in the AVRISP project not correctly toggling just the clock pin
   *  - Fixed TWI_StartTransmission() corrupting the contents of the GPIOR0 register
   *  - Fixed TWI driver not aborting when faced with no response after attempting to address a device on the bus