Fix up non-relative header file include paths (thanks to Kim Blomqvist).

[pub/lufa.git] / Bootloaders / HID / BootloaderHID.txt

diff --git a/Bootloaders/HID/BootloaderHID.txt b/Bootloaders/HID/BootloaderHID.txt
index d32efee..72583fd 100644 (file)
--- a/Bootloaders/HID/BootloaderHID.txt
+++ b/Bootloaders/HID/BootloaderHID.txt
@@ -10,10 +10,10 @@
  *
  *  The following list indicates what microcontrollers are compatible with this demo.
  *
- *  - Series 7 USB AVRs (AT90USBxxx7)
- *  - Series 6 USB AVRs (AT90USBxxx6)
- *  - Series 4 USB AVRs (ATMEGAxxU4)
- *  - Series 2 USB AVRs (AT90USBxx2, ATMEGAxxU2)
+ *  \li Series 7 USB AVRs (AT90USBxxx7)
+ *  \li Series 6 USB AVRs (AT90USBxxx6)
+ *  \li Series 4 USB AVRs (ATMEGAxxU4)
+ *  \li Series 2 USB AVRs (AT90USBxx2, ATMEGAxxU2)
  *
  *  \section SSec_Info USB Information:
  *
@@ -38,7 +38,7 @@
  *       Teensy Programming Protocol Specification</td>
  *  </tr>
  *  <tr>
- *   <td><b>Usable Speeds:</b></td>
+ *   <td><b>Supported USB Speeds:</b></td>
  *   <td>Low Speed Mode \n
  *       Full Speed Mode</td>
  *  </tr>
@@ -51,10 +51,10 @@
  *  from PJRC (used with permission). This bootloader is deliberatley non-compatible with the properietary PJRC
  *  HalfKay bootloader GUI; only the command line interface software accompanying this bootloader will work with it.
  *  
- *  Out of the box this bootloader builds for the AT90USB1287, and will fit into 2KB of bootloader space for the
- *  Series 2 USB AVRs (ATMEGAxxU2, AT90USBxx2) or 4KB of bootloader space for all other models. If you wish to
- *  enlarge this space and/or change the AVR model, you will need to edit the MCU, FLASH_SIZE_KB and
- *  BOOT_SECTION_SIZE_KB values in the accompanying makefile.
+ *  Out of the box this bootloader builds for the AT90USB1287 with an 8KB bootloader section size, and will fit
+ *  into 2KB of bootloader space for the Series 2 USB AVRs (ATMEGAxxU2, AT90USBxx2) or 4KB of bootloader space for
+ *  all other models. If you wish to alter this size and/or change the AVR model, you will need to edit the MCU,
+ *  FLASH_SIZE_KB and BOOT_SECTION_SIZE_KB values in the accompanying makefile.
  *
  *  \section Sec_Installation Driver Installation
  *