make the updater firmware more dynamic for different devices

[pub/USBaspLoader.git] / firmware / bootloaderconfig.h

diff --git a/firmware/bootloaderconfig.h b/firmware/bootloaderconfig.h
index 005d9bb..af67d6e 100644 (file)
--- a/firmware/bootloaderconfig.h
+++ b/firmware/bootloaderconfig.h
@@ -275,6 +275,19 @@ these macros are defined, the boot loader usees them.
  * instead the right content of the flash memory.
  */
 
  * instead the right content of the flash memory.
  */
 

+#ifdef CONFIG_USE__EXCESSIVE_ASSEMBLER
+#      define USE_EXCESSIVE_ASSEMBLER          1
+#else
+#      define USE_EXCESSIVE_ASSEMBLER          0
+#endif
+/* This macro enables large codeareas of hand-optimized assembler code.
+ * WARNING:
+ * It will only work properly on devices with <64k of flash memory and SRAM.
+ * Some configuration macros (when changed) may not be applied correctly
+ * (since their behaviour is raced within asm)!
+ * Nevertheless this feature saves lots of memory.
+ */
+

 //#define SIGNATURE_BYTES             0x1e, 0x93, 0x07, 0     /* ATMega8 */
 /* This macro defines the signature bytes returned by the emulated USBasp to
  * the programmer software. They should match the actual device at least in
 //#define SIGNATURE_BYTES             0x1e, 0x93, 0x07, 0     /* ATMega8 */
 /* This macro defines the signature bytes returned by the emulated USBasp to
  * the programmer software. They should match the actual device at least in


@@ -299,6 +312,10 @@ these macros are defined, the boot loader usees them.
 #   define MCUCSR   MCUSR
 #endif
 
 #   define MCUCSR   MCUSR
 #endif
 

+/* WARNING:
+ * following commands and macros may not be evaluated properly when 'USE_EXCESSIVE_ASSEMBLER"
+ */
+

 static inline void  bootLoaderInit(void)
 {
     PIN_DDR(JUMPER_PORT)  = 0;
 static inline void  bootLoaderInit(void)
 {
     PIN_DDR(JUMPER_PORT)  = 0;