X-Git-Url: http://git.linex4red.de/pub/USBasp.git/blobdiff_plain/5e7319058268e021ae39ca4b9fcabaec0060117b..5b06886dab18711c33c884e8da81b66d0f3f1541:/LUFA/Drivers/USB/Core/Events.h

diff --git a/LUFA/Drivers/USB/Core/Events.h b/LUFA/Drivers/USB/Core/Events.h
index c0a322b26..2ea14bf10 100644
--- a/LUFA/Drivers/USB/Core/Events.h
+++ b/LUFA/Drivers/USB/Core/Events.h
@@ -78,7 +78,7 @@
 			/** Event for USB mode pin level change. This event fires when the USB interface is set to dual role
 			 *  mode, and the UID pin level has changed to indicate a new mode (device or host). This event fires
 			 *  before the mode is switched to the newly indicated mode but after the \ref EVENT_USB_Device_Disconnect
-			 *  event has fired (if connected before the role change).
+			 *  event has fired (if disconnected before the role change).
 			 *
 			 *  \note This event only exists on microcontrollers that support dual role USB modes.
 			 *        \n\n
@@ -183,7 +183,7 @@
 			 *  This event is time-critical; exceeding OS-specific delays within this event handler (typically of around
 			 *  two seconds) will prevent the device from enumerating correctly.
 			 *
-			 *  \note For the smaller series 2 USB AVRs with limited USB controllers, VBUS is not available to the USB controller.
+			 *  \note For the microcontrollers with limited USB controller functionality, VBUS sensing is not available.
 			 *        this means that the current connection state is derived from the bus suspension and wake up events by default,
 			 *        which is not always accurate (host may suspend the bus while still connected). If the actual connection state
 			 *        needs to be determined, VBUS should be routed to an external pin, and the auto-detect behaviour turned off by