X-Git-Url: http://git.linex4red.de/pub/USBasp.git/blobdiff_plain/5a4def747897c1c6ffbe465506d846c7c686d3e9..9d733d44b402ce33c3c41e45b497c2f92be393f5:/LUFA/ManPages/SoftwareBootloaderJump.txt

diff --git a/LUFA/ManPages/SoftwareBootloaderJump.txt b/LUFA/ManPages/SoftwareBootloaderJump.txt
index 2591a8645..1fad85fb7 100644
--- a/LUFA/ManPages/SoftwareBootloaderJump.txt
+++ b/LUFA/ManPages/SoftwareBootloaderJump.txt
@@ -12,12 +12,15 @@
  *  hardware). This might be required because the device does not have any physical user input, or simply
  *  just to streamline the device upgrade process on the host PC.
  *
- *  The following C code snippet may be used to enter the bootloader upon request by the user application.
+ *  The following C code snippets may be used to enter the bootloader upon request by the user application.
  *  By using the watchdog to physically reset the controller, it is ensured that all system hardware is
  *  completely reset to their defaults before the bootloader is run. This is important; since bootloaders
  *  are written to occupy a very limited space, they usually make assumptions about the register states based
  *  on the default values after a hard-reset of the chip.
  *
+ *  \section Sec_SoftareBootAVR8 AVR8 Architecture
+ *  The following software bootloader jump code is written for the AVR8 architecture.
+ *
  *  \code
  *  #include <avr/wdt.h>
  *  #include <avr/io.h>
@@ -44,15 +47,14 @@
  *
  *  void Jump_To_Bootloader(void)
  *  {
- *      // If USB is used, detach from the bus
- *      USB_ShutDown();
+ *      // If USB is used, detach from the bus and reset it
+ *      USB_Disable();
  *
  *      // Disable all interrupts
  *      cli();
  *
  *      // Wait two seconds for the USB detachment to register on the host
- *      for (uint8_t i = 0; i < 128; i++)
- *        _delay_ms(16);
+ *      Delay_MS(2000);
  *
  *      // Set the bootloader key to the magic value and force a reset
  *      Boot_Key = MAGIC_BOOT_KEY;