Spell check all source files once again to find any typos.

[pub/USBasp.git] / Projects / Incomplete / StandaloneProgrammer / Lib / SCSI.c

diff --git a/Projects/Incomplete/StandaloneProgrammer/Lib/SCSI.c b/Projects/Incomplete/StandaloneProgrammer/Lib/SCSI.c
index f69ab64..29f9749 100644 (file)
--- a/Projects/Incomplete/StandaloneProgrammer/Lib/SCSI.c
+++ b/Projects/Incomplete/StandaloneProgrammer/Lib/SCSI.c
@@ -242,22 +242,17 @@ static void SCSI_Command_Send_Diagnostic(USB_ClassInfo_MS_Device_t* const MSInte
 }
 
 /** Command processing for an issued SCSI READ (10) or WRITE (10) command. This command reads in the block start address
- *  and total number of blocks to process, then calls the appropriate low-level dataflash routine to handle the actual
+ *  and total number of blocks to process, then calls the appropriate low-level Dataflash routine to handle the actual
  *  reading and writing of the data.
  *
  *  \param[in] MSInterfaceInfo  Pointer to the Mass Storage class interface structure that the command is associated with
  *  \param[in] IsDataRead  Indicates if the command is a READ (10) command or WRITE (10) command (DATA_READ or DATA_WRITE)
  */
-static void SCSI_Command_ReadWrite_10(USB_ClassInfo_MS_Device_t* const MSInterfaceInfo, const bool IsDataRead)
+static void SCSI_Command_ReadWrite_10(USB_ClassInfo_MS_Device_t* const MSInterfaceInfo,
+                                      const bool IsDataRead)
 {
-       uint32_t BlockAddress;
-       uint16_t TotalBlocks;
-       
-       /* Load in the 32-bit block address (SCSI uses big-endian, so have to reverse the byte order) */
-       BlockAddress = SwapEndian_32(*(uint32_t*)&MSInterfaceInfo->State.CommandBlock.SCSICommandData[2]);
-
-       /* Load in the 16-bit total blocks (SCSI uses big-endian, so have to reverse the byte order) */
-       TotalBlocks  = SwapEndian_16(*(uint16_t*)&MSInterfaceInfo->State.CommandBlock.SCSICommandData[7]);
+       uint32_t BlockAddress = SwapEndian_32(*(uint32_t*)&MSInterfaceInfo->State.CommandBlock.SCSICommandData[2]);
+       uint16_t TotalBlocks  = SwapEndian_16(*(uint16_t*)&MSInterfaceInfo->State.CommandBlock.SCSICommandData[7]);
        
        /* Check if the block address is outside the maximum allowable value for the LUN */
        if (BlockAddress >= VIRTUAL_MEMORY_BLOCKS)