Update UC3 platform driver support to use the bitmasks defined in the header files...

[pub/USBasp.git] / LUFA / Drivers / USB / Core / Events.h

diff --git a/LUFA/Drivers/USB/Core/Events.h b/LUFA/Drivers/USB/Core/Events.h
index c0a322b..8afd3b5 100644 (file)
--- a/LUFA/Drivers/USB/Core/Events.h
+++ b/LUFA/Drivers/USB/Core/Events.h
@@ -78,7 +78,7 @@
                        /** Event for USB mode pin level change. This event fires when the USB interface is set to dual role
                         *  mode, and the UID pin level has changed to indicate a new mode (device or host). This event fires
                         *  before the mode is switched to the newly indicated mode but after the \ref EVENT_USB_Device_Disconnect
-                        *  event has fired (if connected before the role change).
+                        *  event has fired (if disconnected before the role change).
                         *
                         *  \note This event only exists on microcontrollers that support dual role USB modes.
                         *        \n\n
@@ -183,7 +183,7 @@
                         *  This event is time-critical; exceeding OS-specific delays within this event handler (typically of around
                         *  two seconds) will prevent the device from enumerating correctly.
                         *
-                        *  \note For the smaller series 2 USB AVRs with limited USB controllers, VBUS is not available to the USB controller.
+                        *  \note For the microcontrollers with limited USB controller functionality, VBUS sensing is not available.
                         *        this means that the current connection state is derived from the bus suspension and wake up events by default,
                         *        which is not always accurate (host may suspend the bus while still connected). If the actual connection state
                         *        needs to be determined, VBUS should be routed to an external pin, and the auto-detect behaviour turned off by
@@ -249,7 +249,7 @@
                         *  This event is time-critical; exceeding OS-specific delays within this event handler (typically of around
                         *  one second) will prevent the device from enumerating correctly.
                         *
-                        *  This event fires after the value of \ref USB_ConfigurationNumber has been changed.
+                        *  This event fires after the value of \ref USB_Device_ConfigurationNumber has been changed.
                         *
                         *  \note This event does not exist if the \c USB_HOST_ONLY token is supplied to the compiler (see
                         *        \ref Group_USBManagement documentation).