Added board hardware driver support for the Microsin AVR-USB162 development board.

[pub/USBasp.git] / Projects / AVRISP-MKII / Lib / ISP / ISPProtocol.c

diff --git a/Projects/AVRISP-MKII/Lib/ISP/ISPProtocol.c b/Projects/AVRISP-MKII/Lib/ISP/ISPProtocol.c
index 8821ac9..97e0fb3 100644 (file)
--- a/Projects/AVRISP-MKII/Lib/ISP/ISPProtocol.c
+++ b/Projects/AVRISP-MKII/Lib/ISP/ISPProtocol.c
@@ -3,7 +3,7 @@
      Copyright (C) Dean Camera, 2010.
 
   dean [at] fourwalledcubicle [dot] com
-      www.fourwalledcubicle.com
+           www.lufa-lib.org
 */
 
 /*
@@ -64,15 +64,9 @@ void ISPProtocol_EnterISPMode(void)
 
        CurrentAddress = 0;
 
-       /* Set up the synchronous USART to generate the .5MHz recovery clock on XCK pin */
-       UBRR1  = (F_CPU / 500000UL);
-       UCSR1B = (1 << TXEN1);
-       UCSR1C = (1 << UMSEL10) | (1 << UPM11) | (1 << USBS1) | (1 << UCSZ11) | (1 << UCSZ10) | (1 << UCPOL1);
-       DDRD  |= (1 << 5);
-
        /* Perform execution delay, initialize SPI bus */
        ISPProtocol_DelayMS(Enter_ISP_Params.ExecutionDelayMS);
-       ISPTarget_Init();
+       ISPTarget_EnableTargetISP();
 
        /* Continuously attempt to synchronize with the target until either the number of attempts specified
         * by the host has exceeded, or the the device sends back the expected response values */
@@ -124,15 +118,9 @@ void ISPProtocol_LeaveISPMode(void)
        /* Perform pre-exit delay, release the target /RESET, disable the SPI bus and perform the post-exit delay */
        ISPProtocol_DelayMS(Leave_ISP_Params.PreDelayMS);
        ISPTarget_ChangeTargetResetLine(false);
-       ISPTarget_ShutDown();
+       ISPTarget_DisableTargetISP();
        ISPProtocol_DelayMS(Leave_ISP_Params.PostDelayMS);
 
-       /* Turn off the synchronous USART to terminate the recovery clock on XCK pin */
-       UBRR1  = (F_CPU / 500000UL);
-       UCSR1B = (1 << TXEN1);
-       UCSR1C = (1 << UMSEL10) | (1 << UPM11) | (1 << USBS1) | (1 << UCSZ11) | (1 << UCSZ10) | (1 << UCPOL1);
-       DDRD  &= ~(1 << 5);
-
        Endpoint_Write_Byte(CMD_LEAVE_PROGMODE_ISP);
        Endpoint_Write_Byte(STATUS_CMD_OK);
        Endpoint_ClearIN();