MassStorageBootloader: Move more code into AUX_BOOT_SECTION to save space in small...

[pub/USBasp.git] / Bootloaders / Printer / BootloaderPrinter.txt

diff --git a/Bootloaders/Printer/BootloaderPrinter.txt b/Bootloaders/Printer/BootloaderPrinter.txt
index 99dc7d5..d9aa796 100644 (file)
--- a/Bootloaders/Printer/BootloaderPrinter.txt
+++ b/Bootloaders/Printer/BootloaderPrinter.txt
@@ -61,9 +61,9 @@
  *
  *  The are two behaviours of this bootloader, depending on the device's fuses:
  *
- *  <b>If the device's BOOTRST fuse is set</b>, the bootloader will run any time the system is not reset from
+ *  <b>If the device's BOOTRST fuse is set</b>, the bootloader will run any time the system is reset from
  *  the external reset pin, unless no valid user application has been loaded. To initiate the bootloader, the
- *  device's external reset pin should be grounded.
+ *  device's external reset pin should be grounded momentarily.
  *
  *  <b>If the device's BOOTRST fuse is not set</b>, the bootloader will run only if initiated via a software
  *  jump, or if the \c HWB pin was low during the last device reset (if the \c HWBE fuse is set).
@@ -187,12 +187,6 @@
  *  are unable to handle true plain-text printing. For best results, the low
  *  level \c lpr command should be used to print new firmware to the bootloader.
  *
- *  \par After loading an application, it is not run automatically on startup.
- *  Some USB AVR boards ship with the BOOTRST fuse set, causing the bootloader
- *  to run automatically when the device is reset. In most cases, the BOOTRST
- *  fuse should be disabled and the HWBE fuse used instead to run the bootloader
- *  when needed.
- *
  *  \section Sec_Options Project Options
  *
  *  The following defines can be found in this demo, which can control the demo behaviour when defined, or changed in value.