Add new RNDIS_Host_IsPacketReceived(), RNDIS_Device_ReadPacket() and RNDIS_Device_Wri...

[pub/USBasp.git] / LUFA / ManPages / SoftwareBootloaderJump.txt

diff --git a/LUFA/ManPages/SoftwareBootloaderJump.txt b/LUFA/ManPages/SoftwareBootloaderJump.txt
index d0b41e1..1fad85f 100644 (file)
--- a/LUFA/ManPages/SoftwareBootloaderJump.txt
+++ b/LUFA/ManPages/SoftwareBootloaderJump.txt
@@ -12,12 +12,15 @@
  *  hardware). This might be required because the device does not have any physical user input, or simply
  *  just to streamline the device upgrade process on the host PC.
  *
  *  hardware). This might be required because the device does not have any physical user input, or simply
  *  just to streamline the device upgrade process on the host PC.
  *

- *  The following C code snippet may be used to enter the bootloader upon request by the user application.
+ *  The following C code snippets may be used to enter the bootloader upon request by the user application.

  *  By using the watchdog to physically reset the controller, it is ensured that all system hardware is
  *  completely reset to their defaults before the bootloader is run. This is important; since bootloaders
  *  are written to occupy a very limited space, they usually make assumptions about the register states based
  *  on the default values after a hard-reset of the chip.
  *
  *  By using the watchdog to physically reset the controller, it is ensured that all system hardware is
  *  completely reset to their defaults before the bootloader is run. This is important; since bootloaders
  *  are written to occupy a very limited space, they usually make assumptions about the register states based
  *  on the default values after a hard-reset of the chip.
  *

+ *  \section Sec_SoftareBootAVR8 AVR8 Architecture
+ *  The following software bootloader jump code is written for the AVR8 architecture.
+ *

  *  \code
  *  #include <avr/wdt.h>
  *  #include <avr/io.h>
  *  \code
  *  #include <avr/wdt.h>
  *  #include <avr/io.h>


@@ -51,8 +54,7 @@
  *      cli();
  *
  *      // Wait two seconds for the USB detachment to register on the host
  *      cli();
  *
  *      // Wait two seconds for the USB detachment to register on the host

- *      for (uint8_t i = 0; i < 128; i++)
- *        _delay_ms(16);
+ *      Delay_MS(2000);

  *
  *      // Set the bootloader key to the magic value and force a reset
  *      Boot_Key = MAGIC_BOOT_KEY;
  *
  *      // Set the bootloader key to the magic value and force a reset
  *      Boot_Key = MAGIC_BOOT_KEY;