Add OLIMEX AVR-ISP-MK2 board to the BoardDriverTest build test.

[pub/USBasp.git] / Demos / Device / ClassDriver / VirtualSerialMassStorage / VirtualSerialMassStorage.txt

diff --git a/Demos/Device/ClassDriver/VirtualSerialMassStorage/VirtualSerialMassStorage.txt b/Demos/Device/ClassDriver/VirtualSerialMassStorage/VirtualSerialMassStorage.txt
index ff1d3c2..0422441 100644 (file)
--- a/Demos/Device/ClassDriver/VirtualSerialMassStorage/VirtualSerialMassStorage.txt
+++ b/Demos/Device/ClassDriver/VirtualSerialMassStorage/VirtualSerialMassStorage.txt
@@ -10,9 +10,9 @@
  *
  *  The following list indicates what microcontrollers are compatible with this demo.
  *
- *  - Series 7 USB AVRs (AT90USBxxx7)
- *  - Series 6 USB AVRs (AT90USBxxx6)
- *  - Series 4 USB AVRs (ATMEGAxxU4)
+ *  \li Series 7 USB AVRs (AT90USBxxx7)
+ *  \li Series 6 USB AVRs (AT90USBxxx6)
+ *  \li Series 4 USB AVRs (ATMEGAxxU4)
  *
  *  \section Sec_Info USB Information:
  *
@@ -42,7 +42,7 @@
  *        SCSI Block Commands Specification</td>
  *   </tr>
  *   <tr>
- *    <td><b>Usable Speeds:</b></td>
+ *    <td><b>Supported USB Speeds:</b></td>
  *    <td>Full Speed Mode</td>
  *   </tr>
  *  </table>
@@ -77,10 +77,14 @@
  *   </tr>
  *   <tr>
  *    <td>TOTAL_LUNS</td>
- *    <td>MassStorage.h</td>
+ *    <td>AppConfig.h</td>
  *    <td>Total number of Logical Units (drives) in the device. The total device capacity is shared equally between each drive -
  *        this can be set to any positive non-zero amount.</td>
  *   </tr>
- *  </table>
+ *   <tr>
+ *    <td>DISK_READ_ONLY</td>
+ *    <td>AppConfig.h</td>
+ *    <td>Configuration define, indicating if the disk should be write protected or not.</td>
+ *   </tr>
  */